Our galvanized male thread conduit connector joins a conduit to a junction box, enclosure, or threaded fitting. One end takes the conduit, secured without threading the pipe, and the other end carries an external (male) thread that passes through the knockout or hole in the box and is fixed with a locknut. It is made from zinc-coated steel to match galvanized conduit, and it gives a firm, tidy connection at box entries in dry indoor routes.
Or email admin@wananelectric.com, or call or WhatsApp +86 18823394830.
Key Features
- Firm box connection: the male thread passes through the box wall and is locked with a nut, so the conduit stays fixed to the box
- Quick on the conduit side: the conduit is pushed in and secured, with no threading of the pipe
- Zinc-coated steel: the galvanized finish matches the conduit and protects the steel from rust in normal indoor conditions
- Smooth bore: a clean opening at the entry helps protect cables from sharp edges
- Locknut included or available: the nut holds the fitting tight against the box wall
- Matched to the conduit: made to fit the outer diameter of our galvanized conduit
- Part of a full system: works with our boxes, couplings, and conduit
Specifications
| Conduit Size | Male Thread Size | Thread Length (mm) | Overall Length (mm) |
|---|---|---|---|
| 20 | [confirm] | [confirm] | [confirm] |
| 25 | [confirm] | [confirm] | [confirm] |
| 32 | [confirm] | [confirm] | [confirm] |
| 40 | [confirm] | [confirm] | [confirm] |
| 50 | [confirm] | [confirm] | [confirm] |
| 63 | [confirm] | [confirm] | [confirm] |
Material: zinc-coated steel, [confirm process: electro-galvanized or other]. Securing method on the conduit side: [confirm: set-screw (for JDG) or snap-press (for KBG)]. Thread standard: [confirm: metric, PG, or other]. Locknut: [confirm: included or sold separately]. Other sizes are available on request.
Where to Use It
- Connecting conduit to junction boxes and switch boxes
- Connecting conduit to distribution boards and enclosures
- Connecting conduit to threaded fittings and equipment
- Concealed and exposed routes in offices, shops, and commercial buildings
- Factories, workshops, and equipment rooms with dry conditions
Good to Know
- Match the thread: the thread size and standard must match the box knockout or the threaded fitting, so confirm both before ordering
- Match the conduit: set-screw ends go with JDG conduit, and snap-press ends go with KBG conduit
- Tighten the locknut: a firmly tightened nut keeps the connector fixed and helps keep the conduit electrically continuous. Check continuity according to your project specification
- Dry locations: this fitting is for dry indoor routes. It does not seal against water by itself, so use sealed fittings and a gasket for outdoor or damp routes
- Protect the cables: deburr the conduit end before insertion, and fit a bushing where the project requires it
Why Choose Wanan
Wanan has been manufacturing electrical conduit and cable management products since 2004, with a 20,000 m² factory. We supply EPC contractors, MEP contractors, and distributors, with drawings, OEM/ODM service, and documents such as material certificates and inspection reports on request. Send us your conduit type, sizes, and quantity, and our team will quote conduit, boxes, and fittings together.
Or email admin@wananelectric.com, or call or WhatsApp +86 18823394830.
